GEKO ACOUSTIC BOX FAN - FLOW RATE = 1000 METRE/HR / 150mm Spigots
GEKO ACOUSTIC BOX FAN - FLOW RATE = 1000 METRE/HR / 150mm SpigotsGeko MDF box fan.
Geko acoustic box fans are a MDF constructed box with a torin fan mounted inside.
These fans are very silent running and do not make a humming noise when operated with a fan speed controller.
Decibel Rating 53.2 dbaGeko fans are efficient and reliable, making use of a prestige Torin Sifan motor; they move a LOT of air, and they’re extremely quiet.
The Gekko Acoustic Box Fan should be mounted in a suitable place on a flat surface. Ideally, acoustic ducting should be used with this product to maintain sound at minimum levels. Acoustic fans can only do so much to reduce sound. As air travels through ducting, added noise is generated as it moves over ridges and bends, creating friction.
Ducting should be attached to the vents on the Gekko fan with duct clips (supplied separately) to ensure that the join is secure. If ducting comes loose and the extraction system is compromised, unwanted smells may escape, and heat and humidity levels may rise. For the same reason, it’s advisable to connect the inlet vent of the fan to the carbon filter using a fast clamp (also available separately).
The Gekko Acoustic Box Fan is supplied with a female IEC Connector, so that it can easily be connected to a power supply with a standard kettle lead. The Gekko Acoustic Box Fan has a clamp which closes over the IEC connection, ensuring that the cable cannot be accidentally pulled out. The supplied male IEC cable is around 165cm long; locating the Gekko fan further away than this from a power supply will require the purchasing of a separate cable.
Do not under any circumstances put your fingers into the spinning blades of a fan. Even a small fan has enough power to cause severe injury and loss of fingers. Just don’t do it, no matter how tempted you are. Keep ducting runs as short as possible as every metre of ducting reduces the flow-rate that the fan can achieve. The more ducting attached, the lower the air-flow. Bear in mind that a carbon filter will reduce the air-flow that your fan can achieve by about 25% just on its own. When turning a corner with ducting try to create a swept bend rather than a sharp knee as this will reduce air-flow by the least amount and also help to keep wind-noise down. To further keep wind-noise down to a minimum, stretch flexi-ducting out as much as possible or use acoustic ducting.
Why choose the Gekko box fan?Moisture resistant MDF panels to increase your box life.
Hanging spacesaver option available to increase your grow potential.
Maximum noise reduction.
Torin Sifan Fan
Roll top flange spigot to make connecting any ducting easier.
Lightweight so you don’t break your back.
U.K. Manufactured, quality in a box.
PU and Screw assembled, let’s keep it together.
CNC precision cut
Write a reviewYour Name:
Your Review: Note: HTML is not translated!
Rating: Bad Good
Enter the code in the box below: